Clean. Align.
Apply.
The same three-step installation applies to the 500, 750, 810, 1000 and 1200 HP winged emblems.
Step 1 — Clean and dry
Wash the mounting area, dry it completely, then use the included prep pad. The surface must be free of wax, oil and moisture.
Step 2 — Center and check
Use the included installation instruction card with ruler. Center the Kilo Performance horsepower badge beneath the factory 5.0 emblem with a 1/4-inch vertical gap. Check both sides before removing the backing.
Step 3 — Peel and apply
Remove the adhesive backing, place the emblem once, and press firmly across the full badge. Follow the printed guide for adhesive cure and washing instructions.
Permanent automotive adhesive is not designed for trial placement. Check alignment before removing the backing. We do not accept change-of-mind returns. Damage caused by installation or removal is not a manufacturing defect. Installation does not remove rights for an unrelated defect or rights provided by law.
Typical installation takes approximately 5–10 minutes after surface preparation. Take your time with alignment; a careful dry fit matters more than speed.